Installation of the wired barcode scanner
Connect the supplied wired barcode scanner(s) to the designated workstations, no further driver installation is necessary.
Print out the page of this document and use the barcode scanner to scan the following two Metrologic configuration barcodes, thus converting 12-digit UPC barcodes into 13-digit barcodes and supporting German characters such as umlauts and the "ß":
How to install the Bluetooth wireless barcode scanner
Connect the supplied charging station of the Bluetooth wireless barcode scanner to the designated workstations, no further driver installation is necessary.
Insert the Bluetooth wireless barcode scanner into the charging cradle and wait for 10 minutes (the blue LED should light or blink during charging).
Remove the Bluetooth wireless barcode scanner from the charging cradle and first scan the barcode printed inside the charging cradle.
Print out the page of this document and use the barcode scanner to scan the following two Metrologic configuration barcodes, thus converting 12-digit UPC barcodes into 13-digit barcodes and supporting German characters such as umlauts and the "ß":
Configuration of the wireless barcode scanner Unitech MS 350
If you are using the Bluetooth barcode scanner Unitech MS 350 for the first time, it may be possible that it does not contain the German keyboard layout and the UPCA setting for scanning 12-digit barcodes is deactivated. As a result, errors occur when scanning storage locations or items. Here's how to change the scanner to the German keyboard layout.
How to configure the German keyboard layout
Connect the supplied charging station of the Bluetooth wireless barcode scanner to the designated workstations, no further driver installation is necessary.
Insert the Bluetooth wireless barcode scanner into the charging cradle and wait 10 minutes (the LED must be lit or flashing during charging).
Remove the Bluetooth wireless barcode scanner from the charging cradle and first scan the barcode printed inside the charging cradle.
Print out the page of this document and use the barcode scanner to scan the following Unitech configuration barcodes, so the German characters such as umlauts and the "ß" are supported. (Alternatively you can try to scan the barcodes from the screen)
Please proceed in the order from top to bottom (Program, Keyboard, 0, 4, Finish, Exit)
How to configure the UPCA setting
Connect the supplied charging station of the Bluetooth wireless barcode scanner to the designated workstations, no further driver installation is necessary.
Insert the Bluetooth wireless barcode scanner into the charging cradle and wait 10 minutes (the LED must be lit or flashing during charging).
Remove the Bluetooth wireless barcode scanner from the charging cradle and first scan the barcode printed inside the charging cradle.
Print the page of this document and use the barcode scanner to scan the following Unitech configuration barcodes, converting 12-digit UPC barcodes into 13-digit barcodes. (Alternatively you can try to scan the barcodes from the screen)
Please proceed in the order from top to bottom (Program, Truncation, 0, 0, Finish, Exit)